Headset

It is not recommended to use an amp with the Orbit headset because the standard line level voltage must not be exceeded. If the amp outputs more than the line level, the headset may experience distortion or damage.

Charging the Headset When the charging cable is connected the LED will indicate the status. Status LED LED solid red > Charging LED off > Fully charged “Battery low” voice prompt plays at 15% battery. To disable USB charging, hold down the headphone volume wheel for 2 seconds.

Cloud MIX 2 Manually Pairing USB Adapter 1. Plug the USB Adapter into a support device. 2. Make sure headset is powered off, then press and hold the [Power] button for 10 seconds. The headset status LED will begin flashing white quickly. 3. Press and hold the USB adapter button for 10 seconds until

Using the Ngenuity Application from here, go to the headset panel and click on the battery icon. There are several options for time intervals and to disable the feature completely

Manually Pairing the Headset and USB Adapter While the headset is powered off, hold down the power button until the headset earcup LEDs starts blinking rapidly. The headset is now in pairing mode. While the USB adapter is plugged in, use a small tool (e.g. paper clip, SIM tray ejector, etc.) to hold

Although Cloud Flight S is compatible with PS4, the chat mixer feature is only supported on PC.

Power on / off: Hold button for 2 seconds to power headset on / off. Battery level status: Press button to check the battery level. The status LED will automatically turn off to conserve battery life. Battery Level Headset Status LED 61% to 100% Solid-fade Green 21% to 60% Solid-fade Yellow 10% to 2

HYPERX CLOUD FLIGHT HEADSET – HSCFFirmware Update Rev. 3116/4103 Part Numbers: HX-HSCF-BK Description: This firmware update contains two different sets of firmware: Rev. 3116 for build AxxLF/BxxLF and Rev. 4103 for CxxLF. The updater will automatically flash the correct firmware based on the build o

Right-click on the sound icon in the system tray and select Sound Settings. Set the output device to Headphones (HyperX Cloud Flight 2 Wireless). Set the input device to Microphone (HyperX Cloud Flight 2 Wireless).

Connecting the CloudX Flight 2 with PC Slide the headset wireless mode switch to adapter mode Connect the USB wireless dongle to your device Power ON the headset