耳機

Cloud Alpha 2 Wireless - Firmware v121 Changelog Fixed an issue where the headset microphone gain level is set too low when restarting a recording audio stream quickly in adapter mode. Fixed the headset Bluetooth searching LED pattern. Improved the software backend integration. ​Firmware & Updater G

Performing a hardware reset on the headset will do a soft reset on all the internal hardware. This may be useful if the headset has unusual behavior, such as unresponsive controls. To perform a hardware reset, press and hold the mic mute button and the multifunction button for 5 seconds. The headset

Cloud III Quick Start Guide

Headphone Driver: Dynamic, 40mm with neodymium magnets Form factor: Over ear, circumaural, closed back Frequency response: 10 Hz – 25 kHz Impedance: 32.5 Ω Sensitivity: 95 dBSPL/mW at 1 kHz T.H.D.: ≤ 2% Frame type: Plastic Ear cushions: Soft foam & fabric Microphone Element: Electret condenser micro

Slide the wireless mode switch to the Bluetooth symbol. The headset will enter Bluetooth pairing on the first setup. Go to your device Bluetooth settings, search and connect to "HyperX CloudX Stinger 3 Wireless".

Usage (Xbox One™) To use the headset with Xbox One™, connect the 3.5mm plug on the headset directly to the 3.5mm jack on the Xbox One™ controller* If your Xbox One™ controller does not have a 3.5mm jack, you will need the Xbox One™ Stereo Headset adapter (sold separately) that plugs into the Xbox On

Volume Wheel - Scroll up or down to adjust volume level

接收器模式 1. 將模式開關滑動到「無線」模式。 2. 將 USB 無線接收器連接到 PC 或遊戲機。 3. 打開耳機電源。 藍牙模式 1. 將模式開關滑動到藍牙模式。首次設定時，耳機指示燈會閃爍藍光。 2. 開啟裝置的藍牙設置，搜尋並連接「HyperX Cloud Jet」。 藍牙配對 1. 將模式開關滑動到藍牙模式，確認耳機處於電源 關閉 狀態。 2. 按住多功能按鈕 5 秒鐘。 LED 指示燈呈 快速 藍色閃爍時，表示已進入配對模式。 語音提示將提示：「Bluetooth pairing」。 3. 進入裝置的藍牙設定並連接至“HyperX Cloud Jet“

It is recommended to fully charge your headset before first use. ​ Charge Status Status LED Fully Charged Solid Green 61% - 99% Breathing Green 21% - 60% Breathing Yellow < 20% Breathing Red

Performing a factory reset on the headset will reset the headset and base station to default settings and remove pairing info with paired Bluetooth devices. To perform the factory reset from the headset side: Press and hold the power button and the multifunction button for 10 seconds to initiate fac