耳机

云聊天快速入门指南

Cloud Orbit S 耳机规格 驱动单元：平面换能器，100 毫米 类型：全罩式，封闭式后背 频率响应：10Hz–50,000Hz 声压级：>120 dB；总谐波失真：< 0.1% (1 kHz, 1 mW) 重量：368克 模式 Orbit：3D音频 Orbit S：支持头部追踪的 3D 音频 电缆长度 USB Type-C 转 USB Type-A：3米 USB Type-C 转 USB Type-C：1.5米 3.5毫米插头（4极）：1.2米 麦克风 元件：驻极体电容式麦克风 极坐标模式：单向 电池续航时间* 模拟 3.5 毫米模式：10 小时 *测试时耳机音量设置为 50%

​ A. Mic mute button B. Microphone port C. Volume Wheel D. Detachable Microphone E. Microphone Mute LED F. USB Dongle G. USB-C to USB-A Adapter

Battery Level Status - Press Power Button to check the battery level The Status LED will automatically turn off to conserve battery life. 61%-100% - Solid-fade Green 21%-60% - Solid-fade Yellow 10%-20% - Solid-fade Red

通过蓝牙®设置无线耳机 蓝牙配对 在耳机关闭的情况下，按住电源按钮 5 秒钟。 LED 指示灯将红蓝交替闪烁。在您的蓝牙设备上，搜索并连接 HyperX Cloud MIX。连接成功后，指示灯将每 5 秒闪烁一次蓝色。 开/关 开机/关机 – 按住电源按钮 2 秒

Using with PC, Chromebook, or Notebook ​

1. Plug in the wireless dongle and launch NGENUITY 2. Click on the Headset tab 3. Click “Install” on the “Audio Drivers Required” prompt 4. Wait until the drivers are finished installing 5. Click “OK, Will Do” on the “Drivers Installed” prompt 6. Restart your PC

Fully Charged - Solid Green 61%-99% - Breathing Green 21%-60% - Breathing Yellow

*Supported only on compatible HP OMEN systems and a compatible Cloud II Core Wireless version. Pairing to HP OMEN System 1. In Ngenuity Software, navigate to the "Settings" page 2. Under "HyperX Internal Wireless Audio Adapter" device, click on "Initiate Pairing Mode" 3. Follow the On-Screen Instruc

Charging the Headset It is recommended to fully charge your headset before first use. When charging the headset, the headset status LED will indicate the current charge status. Wired Charging: To charge the headset via wired, plug the headset to a USB port with the USB charge cable.