Pulsefire Haste 2 Pro

The Pulsefire Haste 2 Pro is supported with Windows Dynamic Lighting (WDL). Windows Dynamic Lighting (WDL) in Windows 11 allows lighting control outside of NGENUITY. Please refer to WDL documentation for supported effects.

The mouse can’t operate on Bluetooth and 2.4G simultaneously, as the power switch allows only one connection mode at a time. However, you can use both Bluetooth and 2.4G on different computers. Pairing information for Bluetooth is saved and will auto-connect once in BT power mode. When switching bet

1. Switch the power mode to "OFF". 2. Remove the PTFE Skates with a flat, plastic tool (e.g. spudger, fingernails) to reveal the 4x Torx 6 Security Screws below the feet. 3. Gently separate and lift the top shell from the bottom shell in an upward motion. 4. Locate and remove the battery secured wit

The Pulsefire Haste 2 Pro has one onboard memory profile for storing a configuration from NGENUITY. Saved settings will remain in memory until either: Being overwritten within NGENUITY -> [Save to Mouse]. A factory reset is performed. On-board mouse settings will carry over onto any system the mouse

Does the Haste 2 Pro support dust or water resistance? It does not! Please do not test this in any method or else it will void your warranty.

To reset the mouse's Instant Pair pairing table: Clear the Laptop's pairing table first. On the compatible OMEN laptop it's paired to via Instant Pair, go into NGENUITY. Go into NGENUITY Settings. Find the mouse in the device list, and click Forget Device. Clear the mouse's pairing table: Also insid

This specific process will only work if the mouse and the OMEN Laptop have never paired with each other. Additionally, the firmware of the mouse must be version 1121 or higher. Move the mouse close to the compatible OMEN Laptop, within 20cm or less. The module the mouse needs to pair with is located

What's the difference of battery life when using 1000Hz and 4000Hz Polling Rate? 1000Hz: Up to 90 Hours 4000Hz: Up to 30 Hours This was tested continuously while turning off all the lighting and paired wirelessly. Your experience will vary based on your usage!

To force the mouse to connect via Instant Pair to a compatible system: Move the mouse power switch to “OFF”. Hold the “Back Button” on the mouse. While holding the Back Button, move power switch to “2.4G”. The mouse will blink Orange four times when successfully connected to the compatible system vi

To customize lighting, DPI, macro settings, and more, download HyperX NGENUITY software at: NGENUITY