Cloud Stinger 2 Series

Headphone Driver: Dynamic, 50mm with neodymium magnets Form factor: Over ear, circumaural, closed back Frequency response: 10 Hz – 28 kHz Impedance: 32 Ω Sensitivity: 97.5 dBSPL/mW at 1 kHz T.H.D.: ≤ 2% Frame type: Plastic Ear cushions: Memory foam and premium leatherette Microphone Element: Electre

​ Status LED Status Battery Level LED Searching: Slow breathing green Connected: 90% - 100% Solid green for 5s 10% - 90% Blinking green for 10s < 10% Blinking red for 10s *Battery level indication *The status LED will automatically turn off to conserve battery life Power Button • Hold for 3 seconds

Cloud Stinger 2 Wireless User Manual

1. Plug in the wireless dongle and launch NGENUITY 2. Click on the Headset tab 3. Click “Install” on the “Audio Drivers Required” prompt 4. Wait until the drivers are finished installing 5. Click “OK, Will Do” on the “Drivers Installed” prompt 6. Restart your PC

Operation ​ Cloud Stinger 2 Wireless microphone positions

Microphone Down Position - Microphone Mute Off Mcirphone Up Position - Microphone Mute On

1. Connect the wireless adapter to the PlayStation 4 console. 2. Set Input Device to USB Headset (HyperX Cloud Stinger 2 Wireless). 3. Set Output Device to USB Headset (HyperX Cloud Stinger 2 Wireless). 4. Set Output to Headphones to All Audio. 5. Set Volume Control (Headphones) to maximum.

​ Plug the headset into the controller via 3.5mm jack

Cloud Stinger 2 Wireless Quick Start Guide

A. Swivel to mute microphone B. Status LED C. Power button D. USB-C charge port E. Volume wheel F. USB wireless adapter G. Wireless pairing pin hole H. Wireless status LED I. USB-C charge cable