Headset

Cloud Stinger Core 7.1 Connecting with USB Adapter ​

In NGENUITY software, the headset can be set to prioritize voice notifications or tone notifications. If voice prompts are set to off, the headset will switch to tones for the following notifications: Power on / off Adapter connected / disconnected Bluetooth connected / disconnected Volume at minimu

1. Slide the headset wireless mode switch to the WiFi symbol and the base station mode switch to "HEADSET". 2. Power ON the headset.

Cloud MIX Specifications Headphone Driver: Custom dynamic, 40mm with neodymium magnets Type: Circumaural, closed-back Frequency response: 10Hz–40,000Hz Impedance: 40 Ω Sound pressure level: 100dBSPL/mW at 1kHz THD: < 2% Weight: 260g Weight with mic: 275g Cable length: Detachable headset cable: 1.3m

PlayStation 4 USB Setup 1. Power on the headset. 2. Hold down the microphone volume wheel for 2 seconds to change audio modes. Repeat this step until the headset plays the voice prompt “2 Channel”. 3. Connect the headset to the PlayStation 4 console with the USB Type-C to USB Type-A cable. 4. From t

Cloud Orbit S Analog 3.5mm Mode 1. Power on the headset 2. Connect the headset to the device’s 3.5mm port with the 3.5mm (4-pole) cable

Usage (Nintendo Switch™) To use the headset with Nintendo Switch™, connect the 3.5mm plug on the headset directly to the 3.5mm jack on the Nintendo Switch™.

Cloud Stinger S Quick Start Guide

Set the headset mode switch to adapter mode (WiFi symbol). While the headset is powered off, hold down the multifunction button until the headset LED starts blinking red/green rapidly. The headset is now in pairing mode. While the USB wireless dongle is plugged in, use a small tool (e.g. paper clip,

If you notice that the audio is not balanced when using the 3D mode on the Orbit S headset, it may need to be centered. Look at the center of your screen and press the 3D button to mark as the focal point for audio. You will notice that moving your head position does not change the point of referenc