麥克風

Microphone Power consumption: 5V 220mA (white light) Sample/bit rate: 48kHz/16-bit Element: Electret condenser microphone Condenser type: Three 14mm condensers Polar patterns: Stereo, Omnidirectional, Cardioid, Bidirectional Frequency response: 20Hz - 20kHz Sensitivity: -36dB (1V/Pa at 1kHz) Cable l

​ ​ A. Tap-to-Mute Sensor B. Gain Control Knob C. Polar Pattern Knob D. Headphone Jack E. USB Cable Port F. USB Cable G. Mount Adapter* *Supports both 3/8” and 5/8” thread sizes

Solocast 快速入門指南

Red - Mute Status Purple - Microphone Gain Level Yellow - Headphone Volume Level Cyan - Monitor/Playback Mix Level

輕觸麥克風頂部即可靜音/取消靜音。 麥克風狀態指示燈將顯示目前的靜音狀態。 ​

PC - The Quadcast's mic monitoring can be disabled by going to Control Panel>Sound>Recording. Select the HyperX microphone and click Properties. Select the Listen tab and then disable "Listen to this device." The Quadcast S can be adjusted through Ngenuity under the Mic monitoring feature MAC - Open

A. 輕觸靜音感應器 B. 麥克風狀態指示燈 C. 麥克風底座 D. 傾斜調整 E. USB-C 連接埠 F. 直立式安裝 G. USB-C 連接線

150Hz High-Pass filter: On- Green ​ Switching on the high-pass filter reduces out rumble or other unwanted low frequencies. The high-pass filter has a cutoff frequency of 150Hz and a roll-off of 12dB/octave. Presence Boost: On - Green ​ Switching on the presence boost enhances upper-mid frequencies,

輕輕握住並轉動麥克風，即可將麥克風從防震架上取下或安裝到防震架上。

​​ A. 冷凝器膠囊 B. 防震架 C.3 針XLR輸出接口 D. 有傾斜調整功能的支架 E. -10dB 衰減開關 F. 80Hz高通濾波器開關 G. Snap on 防噴罩