Cloud III S Wireless

Double press the power button to switch between OMEN gaming laptop connection and USB wireless dongle connection.

Performing a factory reset on the headset will reset the headset to default settings, remove pairing info with paired Bluetooth devices, and remove pairing info with OMEN Instant Pair. Press and hold the Power button and Multi-function button for 10 seconds to initiate factory reset. The power statu

Slide the mode switch to the Bluetooth icon. The headset will enter Bluetooth pairing on the first setup. Power on the headset. Go to your device Bluetooth settings, search, and connect to “HyperX Cloud III S Wireless”. ​

The Cloud III S Wireless is **not** compatible with Xbox.

Power off the headset. Carefully pull the right ear cushion from the headset. Unscrew the 4x Phillips screws to separate the driver cover from the right earcup. Gently separate the cover from the earcup to avoid any damage. Locate and remove the battery secured with the connector. Place new battery

It is recommended to fully charge your headset before first use. To charge the headset, plug the headset to a USB port with the included USB-C charge cable. When charging the headset, the headset status LED will indicate the current charge status. Charge Status Status LED Fully Charged Solid green 6

In NGENUITY software, the headset can be set to prioritize voice notifications or tone notifications. If voice prompts are set to off, the headset will switch to tones for the following notifications: Power on / off Adapter connected / disconnected Bluetooth connected / disconnected Volume at minimu

Slide the mode switch to the Bluetooth icon. Press and hold the Power and Multifunction buttons for 2 seconds to enter Bluetooth pairing mode. Pairing mode is active when the LED blinks blue and the voice prompts says "Bluetooth pairing". ​ ​Go to your device Bluetooth settings, search, and connect

Connect the USB wireless dongle to your device. Set headset mode switch to the WiFi icon. Power on the headset. Set Input Device to USB Headset (HyperX Cloud III S Wireless). Set Output Device to USB Headset (HyperX Cloud III S Wireless). Set Output to Headphones to All Audio. Set Volume Control (He

*This method is only possible if the OMEN laptop has already previously paired with a compatible Instant Pair headset. Open the NGENUITY software. Go to the Settings tab. Under “Connected Hardware,” select HyperX Wireless Embedded Receiver. Click Pair new headset to set the OMEN system in pairing mo