Cloud Alpha 2 Wireless

Cloud Alpha 2 Wireless - Firmware v121 Changelog Fixed an issue where the headset microphone gain level is set too low when restarting a recording audio stream quickly in adapter mode. Fixed the headset Bluetooth searching LED pattern. Improved the software backend integration. ​Firmware & Updater G

Cloud Alpha 2 Wireless Quick Start Guide

Slide the wireless mode switch to Dual mode. The headset will enter Bluetooth pairing on the first setup. Go to your device Bluetooth settings, search, and connect to "HyperX Cloud Alpha 2 Wireless". ​

USB-C port: Connect to any supported system for use in adapter mode eg. PC, PlayStation 5. 3.5mm line out: Output playback audio through line out to a supported device eg. powered speakers, when the base station is set to line out mode. 3.5mm line in: Mix in audio from a supported device eg. Switch

Scroll up and down to adjust volume level.

1. While the headset is powered off, hold down the power button for about 10 seconds until the headset status LED starts blinking white rapidly. The headset is now in pairing mode. 2. While the base station is plugged in and the base station output mode switch is set to headset, hold the top 3 butto

Slide the wireless mode switch to Dual mode. Press and hold both the power button and the multifunction button for 2 seconds. Pairing mode is active when the LED blinks blue and the voice prompt says "Bluetooth pairing". Go to your device's Bluetooth settings and connect to "HyperX Cloud Alpha 2 Wir