Pulsefire Haste 2 Pro

Does the Haste 2 Pro support dust or water resistance? It does not! Please do not test this in any method or else it will void your warranty.

To perform a Factory Reset of the Pulsefire Haste 2 Pro: Hold DPI button and Scroll wheel for 5 seconds. The scroll wheel will flash red 2 times momentarily and disappear once reset has completed. This will reset the following on the mouse: DPI to 800 and 4 profiles Polling Rate to 1000Hz on 2.4GHz

The default polling rate is 1k polling rate. Enable 4k Wireless Polling Rate 1. Power off the mouse completely. 2. Press and hold the DPI button. 3. While holding the DPI button, switch the mouse to 2.4G mode. The wheel LED will fast-blink green four times. To revert to the default 1k polling rate,

To place Pulsefire Haste 2 Pro Wireless into Bluetoogh Pairing Mode. Move mouse power switch to bluetooth icon. Hold the left mouse button, right mouse button, and DPI button simutaneously until the mouse flashes blue. The scroll wheel will flash blue, indicating it is in Pairing Mode. ​ Pairing Mod

The HyperX 26K sensor is our custom variant to the PixArt PAW3395.

To reset the mouse's Instant Pair pairing table: Clear the Laptop's pairing table first. On the compatible OMEN laptop it's paired to via Instant Pair, go into NGENUITY. Go into NGENUITY Settings. Find the mouse in the device list, and click Forget Device. Clear the mouse's pairing table: Also insid

This specific process will only work if the mouse and the OMEN Laptop have never paired with each other. Additionally, the firmware of the mouse must be version 1121 or higher. Move the mouse close to the compatible OMEN Laptop, within 20cm or less. The module the mouse needs to pair with is located

What's the difference of battery life when using 1000Hz and 4000Hz Polling Rate? 1000Hz: Up to 90 Hours 4000Hz: Up to 30 Hours This was tested continuously while turning off all the lighting and paired wirelessly. Your experience will vary based on your usage!

HyperX Pulsefire Haste 2 Pro User Manual

To force the mouse to connect via Instant Pair to a compatible system: Move the mouse power switch to “OFF”. Hold the “Back Button” on the mouse. While holding the Back Button, move power switch to “2.4G”. The mouse will blink Orange four times when successfully connected to the compatible system vi