Controller

Calibration Calibration can address issues related to analog sticks and triggers. To activate calibration mode: Set the mode selection switch to USB. Hold down Start and Select. While still holding down both buttons from the previous step, plug in the USB-C cable. Continue holding down both buttons

​Reset The controller can be manually power cycled by pressing the pinhole button on the rear of the controller. Once you've successfully reset the controller, you must calibrate the device. ​

​​ To connect directly via USB cable (also good for charging at the same time), please connect the controller to the host system using the provided USB-C to USB-A cable and swap it to the cable mode, indicated by the USB symbol. To connect to the 2.4GHz wireless adapter, swap the controller to the 2

​​ Pairing and Connecting The controller must be powered off before attempting to enter pairing mode. 2.4G 1. Set the mode selection switch to 2.4G. 2. Connect the 2.4GHz wireless adapter to the PC. 3. Tap the Home button. The controller will power on and attempt to connect to the 2.4GHz wireless ad

​​ ​ Before first trying to use the controller, please charge it to full. Plug the controller into a USB power source using the provided USB-C to USB-A cable. ​ ​​ ​ The LED status bar will indicate charge level, lighting up progressively more as the battery charges to full.

ขั้นแรก ให้ดูที่ด้านล่างของตัวควบคุม ซึ่งก็คือส่วนที่ปกติจะหันลงพื้นขณะใช้งาน โดยปกติจะมีสติ๊กเกอร์ติดอยู่ตรงไหนสักแห่ง ซึ่งจะมีหมายเลขชิ้นส่วนและชื่อผลิตภัณฑ์อยู่ข้างๆ 4Pxxxx เป็นโครงสร้างที่พบได้บ่อยที่สุด แต่ก็อาจเริ่มต้นด้วยอย่างอื่นได้ รุ่นที่เก่ากว่ามากอาจเริ่มต้นด้วย "KHX-" หรือ "HX-" ตามด้วย

HyperX Clutch Gladiate RGB Lighting Mode Enter Lighting Mode Quickly double-press P1. The power LED will slowly breathe. ​​ Profile and Brightness Press Left or Right on the D-Pad to switch Lighting Profiles: Cycle, Solid, and Breathing. Press Up or Down on the D-Pad to adjust Brightness. ​​ Color a

HyperX Clutch Gladiate RGB Setup Connect the controller with the provided USB cable to your Xbox or PC.

No, these are standard potentiometer based Analog Sticks and Triggers.

Assign/Reassign P2 and P3 Double Press P1. LED will blink Magenta While LED is blinking Magenta, press a button to assign. While LED is fast blinking Magenta, press either P2 or P3 to assign your selected button. Led will blink Green for success, blink Red for invalid selection. Clear individually P