Cloud Family

Usage (with Control Box) Connect the headset’s 3.5mm audio jack to the input jack on the USB control box. The USB control box then connects to a computer using the USB connector on the end of the control box. To ensure that HyperX Cloud II is the default audio device, you must follow these instructi

Technical Specifications ​ Headset • Transducer type: Dynamic 53mm with Neodynium Magnets • Operating principle: Closed • Frequency response: 15Hz-25KHz (earphones) • Nominal impedance: 60 ohm per system • Nominal SPL: 98+/-3dB • T.H.D: < 2% • Power handling capacity: 150mW • Sound coupling to the e

Usage (Direct Connect) with No Control Box Connect your headset directly to your computer, game console, or another device (phone or tablet) that has a 3.5mm audio jack.

Cloud Core Wireless DTS Overview ​ A. Status LED B. Power Button C. Mic Mute / Mic Monitoring button D. Volume Wheel E. USB-C Charge Port F. Microphone Port G. Detachable Microphone H. USB Adapter I. Wireless Pairing Pin Hole J. Wireless Status LED K. USB-C Charge Cable L. DTS Instruction Card

การใช้งานแอปพลิเคชัน Ngenuity จาก ที่นี่ไปที่แผงควบคุมหูฟังแล้วคลิกที่ไอคอนแบตเตอรี่ จะมีตัวเลือกต่างๆ สำหรับช่วงเวลา และตัวเลือกในการปิดใช้งานคุณสมบัตินี้โดยสมบูรณ์

Usage (PlayStation® 4) To use the HyperX Cloud Core headset with PlayStation 4 (PS4™), connect the 3.5mm jack on the headset directly to the PS4 game controller and follow these steps: 1. Turn on your PS4 game console. 2. Navigate to the Settings menu and select it. 3. Highlight the ‘Devices’ menu o

Cloud User Manual

Locate the Wireless Module. Open the OMEN laptop screen. Identify the wireless receiver module located on the top right corner of the screen bezel. Set the Headset to Adapter Mode. Slide the connection mode switch on the headset to WiFi mode. With the headset in Adapter mode, hold down the power but

Plug in the USB dongle and launch NGENUITY. Click on the Headset tab. Click "Install" on the "audio Drivers Required" prompt. Wait until the drivers are finished installing. Click "OK, Will DO" on the "drivers Installed" prompt. Restart your PC.

HyperX Cloud III S Wireless User Manual