헤드폰

Cloud Alpha 2 Wireless - Firmware v121 Changelog Fixed an issue where the headset microphone gain level is set too low when restarting a recording audio stream quickly in adapter mode. Fixed the headset Bluetooth searching LED pattern. Improved the software backend integration. ​Firmware & Updater G

Performing a hardware reset on the headset will do a soft reset on all the internal hardware. This may be useful if the headset has unusual behavior, such as unresponsive controls. To perform a hardware reset, press and hold the mic mute button and the multifunction button for 5 seconds. The headset

Cloud III Quick Start Guide

Headphone Driver: Dynamic, 40mm with neodymium magnets Form factor: Over ear, circumaural, closed back Frequency response: 10 Hz – 25 kHz Impedance: 32.5 Ω Sensitivity: 95 dBSPL/mW at 1 kHz T.H.D.: ≤ 2% Frame type: Plastic Ear cushions: Soft foam & fabric Microphone Element: Electret condenser micro

Slide the wireless mode switch to the Bluetooth symbol. The headset will enter Bluetooth pairing on the first setup. Go to your device Bluetooth settings, search and connect to "HyperX CloudX Stinger 3 Wireless".

Usage (Xbox One™) To use the headset with Xbox One™, connect the 3.5mm plug on the headset directly to the 3.5mm jack on the Xbox One™ controller* If your Xbox One™ controller does not have a 3.5mm jack, you will need the Xbox One™ Stereo Headset adapter (sold separately) that plugs into the Xbox On

Volume Wheel - Scroll up or down to adjust volume level

어댑터 모드 1. 모드 스위치를 무선 모드로 전환하세요. 2. USB 무선 동글을 PC 또는 게임 콘솔에 연결하세요. 3. 헤드셋 전원을 켜세요. 블루투스 모드 1. 모드 스위치를 블루투스 모드로 전환하세요. 처음 설정할 때 헤드셋이 파란색으로 깜빡입니다. 2. 기기의 블루투스 설정으로 이동하여 "HyperX Cloud Jet"을 검색하고 연결하세요. 블루투스 페어링 1. 모드 스위치를 블루투스 모드로 밀어주세요. 전원 끄다 헤드셋. 2. 다기능 버튼을 5초 동안 길게 누르세요. LED가 파란색으로 깜빡이면 페어링 모드가 활성화됩니

It is recommended to fully charge your headset before first use. ​ Charge Status Status LED Fully Charged Solid Green 61% - 99% Breathing Green 21% - 60% Breathing Yellow < 20% Breathing Red

Performing a factory reset on the headset will reset the headset and base station to default settings and remove pairing info with paired Bluetooth devices. To perform the factory reset from the headset side: Press and hold the power button and the multifunction button for 10 seconds to initiate fac