Pulsefire Haste 3 Series

Switch the mouse to 2.4G power mode Connect the wireless desktop dongle to a PC or game console using the included USB cable. For optimal placement, keep the wireless desktop dongle within 20cm of the mouse.

Turn the mouse upside down.Gently slide a plastic pry tool under the edge of a skate.Slowly lift and peel the skate away from the mouse.Repeat for all skates.Remove all leftover adhesive residue and debris. (you may need to use rubbing alcohol and a microfiber cloth to get it completely clean).Allow

A. Left Click Button B. Right Click Button C. Mouse Wheel D. Forward Button E. Back Button F. USB-C Port G. PTFE Skates H. HyperX Performance Sensor I. Power Mode Switch J. DPI Button K. Extra Mouse Skates L. 8K Wireless Desktop Dongle M. USB Charge/Data Cable

Connect the mouse to a PC or game console using the included USB cable. *USB connectivity will override the selected power mode

The default polling rate is 1K Power OFF the mouse completely. Press and hold the DPI button. While holding the DPI button, switch the mouse to 2.4G mode. Repeat cycle to the next polling rate; the wheel LED fast blinks twice. There are 3 default presets: 1000Hz (White) 4000Hz (Cyan) 8000Hz (Magenta

*Warning: Improper or forced battery installation may cause permanent damage and is not covered under warranty. ​ Switch power mode to "OFF". Remove the mouse skates with a flat plastic tool to reveal and unscrew the 4x Torx 2 security screws below. Gently separate and lift the top shell from bottom