Pulsefire Haste 2 Pro

The Pulsefire Haste 2 Pro is supported with Windows Dynamic Lighting (WDL). Windows Dynamic Lighting (WDL) in Windows 11 allows lighting control outside of NGENUITY. Please refer to WDL documentation for supported effects.

The mouse can’t operate on Bluetooth and 2.4G simultaneously, as the power switch allows only one connection mode at a time. However, you can use both Bluetooth and 2.4G on different computers. Pairing information for Bluetooth is saved and will auto-connect once in BT power mode. When switching bet

1. Switch the power mode to "OFF". 2. Remove the PTFE Skates with a flat, plastic tool (e.g. spudger, fingernails) to reveal the 4x Torx 6 Security Screws below the feet. 3. Gently separate and lift the top shell from the bottom shell in an upward motion. 4. Locate and remove the battery secured wit

There are 4 default DPI presets. 400 DPI (red) 800 DPI (blue) 1600 DPI (yellow) 3200 DPI (green) Max DPI Supported: Up to 26000 DPI.

You can customize the following features for the Pulsefire Haste 2 Pro through Ngenuity: Lift Off Distance RGB lighting DPI Macros Polling Rate (2.4G/Wired Only) Button re-assignment

The Pulsefire Haste 2 Pro has one onboard memory profile for storing a configuration from NGENUITY. Saved settings will remain in memory until either: Being overwritten within NGENUITY -> [Save to Mouse]. A factory reset is performed. On-board mouse settings will carry over onto any system the mouse

Does the Haste 2 Pro support dust or water resistance? It does not! Please do not test this in any method or else it will void your warranty.

A. Left Click Button B. Right Click Button C. Mouse Wheel D. DPI Button E. Forward Button F. Back Button G. Magnetic Battery Cover H. HyperX 26k Sensor I. Power Mode Switch J. USB Wireless Dongle Storage K. Grip Tape L. Mouse Skates M. USB 4K Wireless Dongle N. Extension Adapter O. USB Charge/Data C

To reset the mouse's Instant Pair pairing table: Clear the Laptop's pairing table first. On the compatible OMEN laptop it's paired to via Instant Pair, go into NGENUITY. Go into NGENUITY Settings. Find the mouse in the device list, and click Forget Device. Clear the mouse's pairing table: Also insid

This specific process will only work if the mouse and the OMEN Laptop have never paired with each other. Additionally, the firmware of the mouse must be version 1121 or higher. Move the mouse close to the compatible OMEN Laptop, within 20cm or less. The module the mouse needs to pair with is located