Cloud Family

Setting up with PC Right-click the speaker icon > Select Open Sound settings > Select Sound control panel. Playback Device Set the Default Device to “HyperX Cloud III Wireless” Recording Device Set the Default Device to “HyperX Cloud III Wireless”

While the headset is powered off, hold down the power button until the headset status LED starts blinking red / green rapidly. The headset is now in pairing mode. While the USB wireless dongle is plugged in, use a small tool (eg. paper clip, SIM tray ejector, etc.) to hold down the button inside the

استخدام تطبيق Ngenuity من هناانتقل إلى لوحة سماعة الرأس وانقر على أيقونة البطارية. ستجد عدة خيارات لتحديد الفترات الزمنية وتعطيل الميزة بالكامل.

A. Mic mute / mic monitoring button B. Status LED C. Power button D. USB-C charge port E. Microphone port F. Multifunction button G. Volume wheel H. Mode switch I. Removeable earcup plates J. Detachable microphone K. Microphone mute LED L. USB wireless dongle M. Dongle status LED N. Pairing pin hole

Cloud III Wireless Quick Start Guide

Cloud II Overview ​ A. Leatherette Headband w/ HyperX Logo B. Aluminuk Arm to Adjust Headband C. Attached Cable w/3.5mm input jack D. Detachable Microphone with Adjustable Arm and Condenser E. 3.5mm Audio Input Jack F. Extra Set of Ear Cushions G. Control Box Cable w/ USB Connector and Control Box H

Charging It is recommended to fully charge your headset before first use.

Pairing to HP OMEN USB dongle 1. Open NGENUITY. 2. Plug in the optional, external USB dongle which came with the headset. 3. If USB wireless dongle is plugged into supported HP OMEN system, NGENUITY will prompt user if they want to pair the headset to the dongle or continue to use direct system conn

Usage (Xbox® One) To use the HyperX Cloud headset with Xbox® One, you will need the Xbox One adapter (sold separately) that plugs into the Xbox® One controller (pictured below.) Because this adapter has built-in volume controls, you can remove the control box that came with your HyperX Cloud headset

Plug in the USB dongle and launch NGENUITY. Click on the Headset tab. Click "Install" on the "audio Drivers Required" prompt. Wait until the drivers are finished installing. Click "OK, Will DO" on the "drivers Installed" prompt. Restart your PC.