HyperX Clutch Wireless Gaming Controller Calibration

Calibration

Calibration can address issues related to analog sticks and triggers. To activate calibration mode:

1. Set the mode selection switch to USB.

2. Hold down Start and Select.

3. While still holding down both buttons from the previous step, plug in the USB-C cable.

4. Continue holding down both buttons until the controller LED indicators flash, which should occur after approximately 4 seconds.

To conduct calibration while in calibration mode:

5. Rotate the left and right analog sticks three times each, then allow them to return to the neutral position.

6. Press and release the left and right triggers, then allow to return to the neutral position

7. Press Y + D-Pad DOWN to save and exit calibration mode.