Cloud Core Wireless DTS

The Cloud Core Wireless DTS is not compatible with NGENUITY. Any software interaction with the headset will be done through DTS® Sound Unbound®. Please follow the instructions on the included DTS instruction card to enable DTS Headphone:X ®. Please note there is no code to enter for this product; th

Power button Hold button for 3 seconds to power headset on/off Press button once to see the battery level status on the status LED The status LED will automatically turn off after 5 seconds to conserve battery life ​ Charging the Headset It is recommended to fully charge your headset before first us

The headset and USB adapter are automatically paired together out of the box. But if the manual pairing is needed, follow the steps below to pair the headset and USB adapter. 1. While the headset is powered off, hold down the power button until the headset status LED starts blinking red/green rapidl

1. Set Input Device to USB Headset (HyperX Cloud Core Wireless) 2. Set Output Device to USB Headset (HyperX Cloud Core Wireless) 3. Set Output to Headphones to All Audio 4. Set Volume Control (Headphones) to maximum level.

Mic mute / mic monitoring button Press the button to toggle mic mute on/off LED On – Mic muted LED Off – Mic active Hold the button for 3 seconds to toggle mic monitoring on/off The headset will play a double beep notification indicating mic monitoring has been toggled Volume wheel Scroll wheel up a

Headphone Driver: Dynamic, 53mm with neodymium magnets Form factor: Over-ear, circumaural, closed-back Frequency response: 10 Hz – 21 kHz Impedance: 60 Ω Sensitivity: 99 dB SPL/mW at 1 kHz T.H.D.: ≤ 1% Frame type: Aluminum Ear cushions: Memory foam Microphone Element: Electret condenser microphone P

Cloud Core Wireless DTS Overview ​ A. Status LED B. Power Button C. Mic Mute / Mic Monitoring button D. Volume Wheel E. USB-C Charge Port F. Microphone Port G. Detachable Microphone H. USB Adapter I. Wireless Pairing Pin Hole J. Wireless Status LED K. USB-C Charge Cable L. DTS Instruction Card

Setting up with PC 1. Connect the wireless USB adapter to the PC. 2. Power on the headset. 3. Right-click Speaker icon > Select Sounds 4. Under the Playback tab, click on “HyperX Cloud Core Wireless” and click on the Set Default button. 5. Under the Recording tab, click on “HyperX Cloud Core Wireles

If the headset is connected to the wireless USB adapter, the headset will automatically power off after 20 minutes of no playback audio activity. If the headset is not connected to the wireless USB adapter, the headset will automatically power off after 3 minutes.

Cloud Core Wireless DTS User Manual