Controller

Articles - Category Page

  • HyperX Clutch Wireless Gaming Controller Charging Setup

    ​​ ​ Before first trying to use the controller, please charge it to full. Plug the controller into a USB power source using the provided USB-C to USB-A cable. ​ ​​ ​ The LED status bar will indicate charge level, lighting up progressively more as the battery charges to full.

    Knowledge Base Article

  • HyperX Clutch Talon Bluetooth Mode

    LED Status Solid Blue : Connected Blinking Blue: Searching Fast Blinking Blue: Pairing Bluetooth Connections Device #1 Single Press P1 (Blink Once) Device #2 Single Press P1 + P2 (Blink Twice) Device #3 Single Press P1 + P3 (Blinke 3 Times)

    Knowledge Base Article

  • Is the Clutch Gladiate RGB supported in NGENUITY? What are its features?

    No. There is no software support for Clutch Gladiate RGB.

    Knowledge Base Article

  • Clutch Tanto Overview

    A. Analog sticks (L3/R3) B. Xbox button C. Power LED D. ABXY buttons E. View button F. D-Pad G. Share button H. Menu button I. Mode selector J. Bumpers (LB/RB) K. Triggers (LT/RT) L. USB-C port M. USB-A to USB-C adapter N. USB-C to USB-A cable O. 3.5mm Headset Jack

    Knowledge Base Article

  • HyperX Clutch Talon Trigger Locks

    Move slider to unlock or reduce trigger motion

    Knowledge Base Article

  • HyperX Clutch Wireless Gaming Controller Calibration

    Calibration Calibration can address issues related to analog sticks and triggers. To activate calibration mode: Set the mode selection switch to USB. Hold down Start and Select. While still holding down both buttons from the previous step, plug in the USB-C cable. Continue holding down both buttons

    Knowledge Base Article

  • HyperX Clutch Talon Overview

    A. Analog Sticks (L3/R3) B. Xbox Button C. Power LED D. ABXY Buttons E. View Button F. D-Pad G. Share Button H. Menu Button I. Trigger Locks (3 way) J. P2/P3 Buttons K. Connection Switch L. 3.5mm Headset Jack M. P1 Button N. Bumpers (LB/RB) O. Triggers (LT/RT) P. USB-C Port Q. Mobile Clip Connector

    Knowledge Base Article

  • HyperX Clutch Gladiate RGB Lighting Mode

    HyperX Clutch Gladiate RGB Lighting Mode Enter Lighting Mode Quickly double-press P1. The power LED will slowly breathe. ​​ Profile and Brightness Press Left or Right on the D-Pad to switch Lighting Profiles: Cycle, Solid, and Breathing. Press Up or Down on the D-Pad to adjust Brightness. ​​ Color a

    Knowledge Base Article

  • Are there Hall Effect Sticks/Triggers in Clutch Galdiate RGB?

    No, these are standard potentiometer based Analog Sticks and Triggers.

    Knowledge Base Article

  • How do I clean the Clutch Gladiate RGB controller?

    Clean the controller surface with a lightly damp, microfiber cloth.

    Knowledge Base Article