Cloud Orbit Family

Cloud Orbit Specifications Headphone Driver: Planar transducer, 100 mm Type: Circumaural, Closed back Frequency response: 10Hz–50,000Hz Sound pressure level: >120 dB T.H.D.: < 0.1% (1 kHz, 1 mW) Weight: 368g Cable length: USB Type-C to USB Type-A: 3m USB Type-C to USB Type-C: 1.5m 3.5mm plug (4-pole

PlayStation 4 USB Setup 1. Power on the headset. 2. Hold down the microphone volume wheel for 2 seconds to change audio modes. Repeat this step until the headset plays the voice prompt “2 Channel”. 3. Connect the headset to the PlayStation 4 console with the USB Type-C to USB Type-A cable. 4. From t

It is not recommended to use an amp with the Orbit S headset because the standard line level voltage must not be exceeded. If the amp outputs more than the line level, the headset may experience distortion or damage.

When the charging cable is connected, the LED will indicate the status. LED Status Charging: LED solid red Fully charged: LED off “Battery low” voice prompt plays at 15% battery. To disable USB charging, hold down the headphone volume wheel for 2 seconds.

EQ Presets Short press and scroll the microphone volume wheel up or down to change the EQ preset. A voice prompt will tell you which EQ preset the headset is using. Default - Tuned to the Audeze House curve. Foot Steps - Enhances sounds of footsteps. Ballistics - Enhances gunshots and other ballisti

Cloud Orbit S Analog 3.5mm Mode 1. Power on the headset 2. Connect the headset to the device’s 3.5mm port with the 3.5mm (4-pole) cable

Nintendo Switch USB Setup 1. Power on the headset. 2. Hold down the microphone volume wheel for 2 seconds to change audio modes. Repeat this step until the headset plays the voice prompt “2 Channel”. 3. Connect the headset to the Nintendo Switch dock via the USB Type-C to Type-A cable. 4. Hold the H

Cloud Orbit S Specifications Headphone Driver: Planar transducer, 100 mm Type: Circumaural, Closed back Frequency response: 10Hz–50,000Hz Sound pressure level: >120 dB T.H.D.: < 0.1% (1 kHz, 1 mW) Weight: 368g Modes Orbit: 3D audio Orbit S: 3D audio with head tracking Cable length USB Type-C to USB

PlayStation 4 USB Setup 1. Power on the headset. 2. Hold down the microphone volume wheel for 2 seconds to change audio modes. Repeat this step until the headset plays the voice prompt “2 Channel”. 3. Connect the headset to the PlayStation 4 console with the USB Type-C to USB Type-A cable. 4. From t

A. Microphone mute B. Status LED C. Power button D. 3D button E. Microphone port F. USB Type-C port G. 3.5mm port H. Microphone volume wheel I. Headphone volume wheel J. Detachable boom microphone K. USB Type-C to USB Type-A cable L. USB Type-C to USB Type-C cab M. 3.5mm cable (4 pole)