Cloud III S Wireless

Power off the headset. Carefully pull the right ear cushion from the headset. Unscrew the 4x Phillips screws to separate the driver cover from the right earcup. Gently separate the cover from the earcup to avoid any damage. Locate and remove the battery secured with the connector. Place new battery

Slide the mode switch to the Bluetooth icon. Press and hold the Power and Multifunction buttons for 2 seconds to enter Bluetooth pairing mode. Pairing mode is active when the LED blinks blue and the voice prompts says "Bluetooth pairing". ​ ​Go to your device Bluetooth settings, search, and connect

Connect the USB wireless dongle to your device. Set headset mode switch to the WiFi icon. Power on the headset. Set Input Device to USB Headset (HyperX Cloud III S Wireless). Set Output Device to USB Headset (HyperX Cloud III S Wireless). Set Output to Headphones to All Audio. Set Volume Control (He

Instant Pair should be possible as long as the OMEN laptop is “Connection Ready” in NGENUITY settings and the headset has not been previously paired with another OMEN laptop. If either the OMEN laptop or the headset has been paired already, both the laptop and the headset need the Instant Pair pairi

Status LED Status Adapter Mode Bluetooth Mode Pairing Fast blinking white Fast blinking blue Searching Blinking white Blinking blue Connected Solid-fade white for 5 seconds Solid-fade blue for 5 seconds Power Button Power on / off - Hold button for 2 seconds to power headset on / off. Battery level

In NGENUITY software, the headset can be set to prioritize voice notifications or tone notifications. If voice prompts are set to off, the headset will switch to tones for the following notifications: Power on / off Adapter connected / disconnected Bluetooth connected / disconnected Volume at minimu

Connect the USB wireless dongle to your device. Set headset mode switch to the WiFi icon. Power on the headset. To ensure the headset is configured correctly on the PS5, follow the steps below: Go to the home page and select Settings > Sound. Under Microphone, set the following: Input Device: USB He

While the headset is powered off and in adapter mode, hold down the power button until the headset status LED starts blinking white rapidly. The headset is now in pairing mode. While the USB wireless dongle is plugged in, use a small tool (e.g. paper clip, SIM tray ejector, etc.) to hold down the bu

Performing a factory reset on the headset will reset the headset to default settings, remove pairing info with paired Bluetooth devices, and remove pairing info with OMEN Instant Pair. Press and hold the Power button and Multi-function button for 10 seconds to initiate factory reset. The power statu

It is recommended to fully charge your headset before first use. To charge the headset, plug the headset to a USB port with the included USB-C charge cable. When charging the headset, the headset status LED will indicate the current charge status. Charge Status Status LED Fully Charged Solid green 6